I was reading the instructions for one of my figures and there is this note:
Now that part, which is an arm, is not re-attaching like it is designed to do. Is there anything I can do to get that to fit tightly like it used to?"Some Parts are made to detach if excessive force is applied and are designed to be re-attached if separation occurs."
I was thinking about taking a pair of pliers and gently smashing/crushing (Can you gently smash or crush something? ) the joint with the arm in it till it was tight.
Is there a better solution? Will this plastic crack instead?
Or, I was thinking of dabbing the joint with a bit of superglue around the rim of the joint & letting it dry. I was hoping that would make enough of a rise in the plastic to keep that arm tightly inside.
I appreciate all of your expert advice!